|
Types of work done:
- Disassembled, flushed and assembled rotor table.
- The main and auxiliary support of the rotor table has been replaced.
- Intermediate vertical shaft is manufactured.
- Splined shaft is manufactured.
- The rotor cover is restored.
- The bearing seats in the main shaft housing have been restored.
- The cover of the drive shaft housing was restored and the pressure flange was manufactured.
- The rotor threaded holes are calibrated
- A new table cover is made.
- A new slotted half-coupling is manufactured.
- The axle landing site in the rotor housing is bored.
- An axle landing axle hub is manufactured, pressed and welded.
- Rust cleaned and rotor table liner retainers in working condition.
- New knobs with stopper retainer for the rotor table drive shaft
- The body of the rotor is stripped from the welding influx.
- The drive shaft bearings are replaced.
- Replaced cuffs.
- All gaskets have been replaced.
- Completed with hardware.
|
|